Kingston 4GB DDR3 1600MHz CL11 Desktop Memory KVR16N11S8/4
This document describes ValueRAM''s 512M x 64-bit (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. FEATURES - JEDEC standard 1.5V (1.425V ~1.575V) Power Supply - VDDQ = 1.5V (1.425V ~ 1.575V) - 800MHz fCK for 1600Mb/sec/pin - 8 independent internal bank - Programmable CAS Latency: 11, 10, 9, 8, 7, 6 - Programmable Additive Latency: 0, CL - 2, or CL - 1 clock - 8-bit pre-fetch - Burst Length: 8 (Interleave without any limit, sequential with starting address ì000î only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] - Bi-directional Differential Data Strobe - Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) - On Die Termination using ODT pin - Average Refresh Period 7.8us at lower than TCASE 85degree, 3.9us at 85degree < TCASE < 95degree - Asynchronous Reset - PCB : Height 0.740” (18.75mm) or 1.180” (30.00mm)
Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here.
- Manufacturer Warranty
- 12 Months Limited Warranty
- Manufacturer Contact Info
1800 620 569